MK Diamond MK-6000 Series - Manual (Page 7)

7
• Caution must be observed while servicing the machine. Rotating parts can cause injury if
contacted. have all service performed by competent service personnel.
• Operate this machine only in well ventilated areas. aLWaYS ensure that the machine is on level
ground before using.
• NEVER operate this machine in an explosive atmosphere.
• Establish a training program and give a copy of this manual to operators of this equipment. If you
need extra copies, call (800) 421-5830.
SaW BLaDe SaFetY
For complete safety information, refer to ANSI Safety Code B7.1 available through the American National
Standards Institute.
• Inspect the blade, flanges and shafts for damage before installing the blade. NEVER use damaged
or worn blade flanges.
• The blade shaft flanges must be of proper diameter for the size blade being used.
• Inspect the blade, flanges and size shown for each blade size. Do not exceed maximum blade
speed shown, as excessive speed could result in blade breakage. Use onLY blades marked with a
maximum operating speed greater than the blade shaft speed. Verify speed and saw drive
configuration by checking blade shaft RPM and pulley diameters and blade flange diameters.
• Use the correct blade for the type of work being done. Use only reinforced abrasive blades or steel
center diamond blades and flanges supplied with the saw or manufactured for use on concrete saws.
Do not use carbide-tipped blades. Check with the blade manufacturer if you do not know if blade
is correct.
• Make sure the blade and flanges are clean and free of dirt and debris before mounting the blade on
the saw. Verify the blade arbor hole matches the machine spindle before mounting the blade.
aLWaYS mount the blade solidly and firmly. Wrench tighten the arbor nut.
• aLWaYS keep area around the machine clear of obstructions and clear the work area of
unnecessary people. Keep all body parts away from the blade and all other moving parts.
• Before starting the machine, check that all guards are in position and correctly fitted.
NEVER allow blade exposure from the guard to be more than 180 degrees. Do not
operate this machine with any guard removed.
MK-6000 SaW SaFetY