Setup, adjustment & operation – MK Diamond BX-4 User Manual
Page 19

BX-4
19
SETUP, ADJUSTMENT & OPERATION
3. CHOP CUTTING:
• A Chop Cut is performed by cutting completely through
an object in one pass.
• Chop cut setup: Depress Trigger to start (lock if
desired). Position work (1) below the Blade.
• Hold Cutting Table (2) stationary. Using the
Handle (3), lower the Cutting Head to begin cutting.
• Using the Handle (3), continue to lower the Cutting
Head until the cut is complete.
• When the cut is complete, release the Trigger
Switch. Allow the Blade to stop before
removing work. Using the Handle (3) to raise the
Cutting Head.
1
3
2
Cutting
Head
See also other documents in the category MK Diamond Power saws:
- MK-770 (41 pages)
- MK-770 EXP (46 pages)
- MK-660 (44 pages)
- MK-470 (12 pages)
- MK-377 (36 pages)
- MK-370 (36 pages)
- MK-370 EXP (52 pages)
- MK-170 (36 pages)
- MK-145 (32 pages)
- MK-145 220 Volt (32 pages)
- MK-101 (52 pages)
- MK-101 (56 pages)
- MK-101-24 (52 pages)
- MK-101-24 (56 pages)
- MK-101 Pro / Pro24 (56 pages)
- MK-101 Tracker (45 pages)
- MK-101Pro24 JCS (60 pages)
- MK-101 JCS Rental (51 pages)
- MK-101 Lowes (56 pages)
- MK-101 Lowes (52 pages)
- MK-100 (44 pages)
- MK-100 (52 pages)
- MK-100 Tracker (46 pages)
- MK-100 JCS (49 pages)
- TX-3 (52 pages)
- Saw Tent (2 pages)
- MK-112 (28 pages)
- MK-1070 (22 pages)
- MK-212 (52 pages)
- MK-1590 (36 pages)
- MKDX Profile Milling Machine (40 pages)
- MK-EZ Profile Milling Machine (36 pages)
- MK-1503SS (24 pages)
- MK-1080 (44 pages)
- MK-1080 (1 page)
- MK-1080 (3 pages)
- MK-1280 Gas Saw (48 pages)
- MK-1280 Electric Saw (40 pages)
- MK-1280 Rolling Cart (4 pages)
- MK-1270 (Shindaiwa) (28 pages)
- MK-2000 Electric Saws (52 pages)
- MK-2000 Gas (60 pages)
- MK-5005S (56 pages)
- MK-5000 Gas Saws (56 pages)
- BX-3 (36 pages)