MK Diamond MK-1080 - Manual (Page 15)

15
MK-1080 PAVER SAW INSPECTION & SET-UP
UNPACKING
Remove the MK-1080 Paver Saw from the carton and place it on a flat surface. Check contents with list
below:
In your container, you will find one (1) MK-1080 and water basin, one (1) splash guard, one (1) wa-
ter pump, one (1) water pump manual, one (1) rip guide, one (1) blade nut wrench, one (1) owner’s
manual, one (1) warranty card.
CONTENTS
Your MK-1080 Paver Saw has been inventoried and packaged with the greatest of care. Inspect the
contents of carton against the contents list below. Ensure that all items are accounted for and that
they are in sound condition. If there are any missing or damaged parts, call MK Diamond Customer
Service at (800) 262-1575 for instructions before proceeding.
MK-1080 Paver Saw
WATER PUMP
OWNERʼS MANUAL
INTRODUCTION
Pumps are carefully inspected and tested to ensure both safety and operating performance. However, failure to follow the instructions and warnings in this manual may result in pump damage and/or serious injury. Be sure to read and save this manual for future reference.
ASSEMBLY
Your MK-1080 has been shipped from the factory thoroughly inspected. Only minimal assembly is
required.
Splash Guard Water Pump Rip Guide
Water Pump Manual Blade Nut Wrench Owner’s Manual Warranty Card
CAUTION Use proper lifting techniques when lifting the MK-1080.
Before using the machine, check for any broken, worn or damaged parts and replace them imme-
diately.
• ALWAYS keep the machine clean and lubricated.
• ALWAYS unwind the power supply cord completely and check for damage.
• Carefully check the “Technical Data” Label before plugging in the machine. Follow the extension
cord requirements, as recommended on the machine label. Work on a level and clean surface.
NOTICE