MK Diamond MK-660 - Manual (Page 19)

19
MK-660 tile saw asseMBlY
sPlasH GUaRD iNstallatiON
Follow the assembly instructions to prepare your MK-660 Saw for operation.
(A)
Install the retaining thumbscrew
through the washer and Splash
Guard, then align to the hole
(B)
Install the Splash Guard
onto the Blade Guard
wateR PUMP iNstallatiON
(A)
Install Water Pump Discharge
Fitting
(B)
Press one end of the Cooling
Transfer Tube onto the Water
Pump Discharge Fitting
(C)
Slide Cooling Flow Adjusting Clamp
onto the Cooling Transfer Tube
PRe-staRt iNsPeCtiON
Prior to beginning work, a pre-start inspection of the saw should be preformed.
(A)
Ensure the ON/OFF Switch is in
the OFF position
(B)
Verify the movable Cutting
Table moves freely
(C)
Inspect the Diamond Blade for
damage - verify the blade is correct
for the material being cut