Memmert IPS Peltier-cooled incubators - Manual (Page 21)

D24034 | Date 10/2014 21
Putting into operation
4. Putting into operation
Caution:
The first time the appliance is operated, it must not be left unattended until it has reached
the steady state.
4.1 Connecting the appliance
Caution:
Observe the country-specific regulations when mak-
ing connections (e.g. in Germany DIN VDE 0100 with
residual current circuit breaker). Observe the connec-
tion and power ratings (see nameplate and "Technical
Data" on page 13). Make sure to establish a safe PE
conductor connection.
Plug the provided power cable into the rear of the appli-
ance and connect it to the power supply ( Fig. 8 ).
Lay the power cable so that
►
it is always accessible and within reach so it can be disconnected quickly in the event of
failure or emergencies;
►
no one can trip over it;
►
it does not come into contact with any hot parts.
4.2 Switching on
Switch on the appliance by pressing the main switch on
the front of the appliance ( Fig. 9 ).
The starting process is shown by three animated white
dots . If the dots have another colour, an error has . If the dots have another colour, an error has
occurred (see page 29).
After the first start-up, the appliance display is set to
English by default. You can change the language as
described from page 31. However, to get a basic
overview of operating the appliance, you should read
the following chapter first.
Fig. 8 Connect the power
cable to the rear of the appliance
Fig. 8 Fig. 8 Connect the power Connect the power
Hauptschalter
>
Zu der Typenbezeichnung gibt es momentan drei Entwurfsrichtungen,
ich kann Ihnen noch nicht sagen, ob Memmert hierzu schon eine Entscheidung
getroffen hat.
Die hier gezeigt Variante, ist die von uns empfohlene Richtung.
UF 110 PLUS
ON
344
.4
444 4 .
TEMP
Set
°C
°C
FLAP
40
%
TIMER
h d
10 02
End Sept. 29 22 24
FAN
%
0
%
100
ALARM
max
444 .4°C
auto
+/- 0.0 K
min
444 .4°C
O O ON N N N O O N O
Manu
44.Sept
Fig. 9 Switch on appliance