MBT Lighting CX1603 - Manual (Page 7)

10
5 COMMON
INSTRUCTIONS OF FOOT CONTROLLER
1. STAND BY button
Press to change the STAND BY status causing its indicator from flashing to off or from off to flashing.
2. FULL ON button
Press this button down, channel 1 to channel 8 are full on and not controlled by STAND BY
3. STEP UP button
In CHASE mode, press to execute the pattern by one step. pressing for more than one second would execute
the pattern by 10 steps per second.
4. PATTERN UP button
In CHASE mode, press to select pattern by plus one ,press for more than one seconds would increase the
pattern quickly till the maximum and then increase from 01.
5. CONTROL OUTPUT cable
Connect to the FOOT CONTROL located on the rear of DM-16
PIN FUNCTION
1 STEP UP
2 PATTERN UP
3 STAND BY
4 FULL ON
5 COMMON
MIDI SETTING
1. NOTE DATA
NOTE NUMBER VELOCITY FUNCTION
22-81 master level for the pattern turn on/off 1-60 patterns
82-97 channel dimmer identical to that set by FLASH1-16
99 FULL ON
101 execute the pattern by one step
102 change the STAND BY status
2. If MIDI signal disappears, 10 minutes latter the matching indicator is off and the MIDI settings are dumped.
3. To receive MIDI signal, set the MIDI channel according to the setting of MIDI settings are dumped.
4. The patterns turned on by MIDI are not controlled by LEVE knob and not showed in the LCD all turned on
patterns are executed synchronously and the terminal level is synthesized by the levels of the turned on
patterns.
OPERATING INSTRUCTIONS
1. RUN PATTERN
Ⅰ、 Press appropriate function button(s) to select desired chasing mode from AUTO, MANUAL AUDIO AND TAP
SYNC ,the LCD shows the pattern and the step.
Ⅱ、 Press PATTERN + or PATTER- to select desired pattern from 30 built –in patterns(31-60) and 30 variable
patterns(1-30).(If the right two digits show 00, the pattern is blank or had teen deleted)