MBT Lighting CX1603 - Manual (Page 5)

10
mode, Press ASSIGN button first, then press FLASH button to store the present level as ASSIGN
SHIFT +DELETE PROGRAM button
In PROGRAM mode , Press SHFIT + DELETE PROGRAM together to delete present pattern.
20. PATCH button
Press this button for more than one seconds to enter or leave PATCH mode, In PATCH mode. the LCD
show the level with the left two digits and shows DMX channel NO. with the right two digits . When the left
two digits show 00, the DMX channel level is 0, if it shows FF, the DMX channel level is maximum, and if it
shows 01 to 16, the DMX channel level is 1 to 16 channel level , In MIDI CHANNEL mode, this button is
invalid.
SHIFT+MIDI AHANNEL button
Press SHIFT+MIDM CHANNEL together for more than one second to enter or leave MIDI CHAN-NEL
mode, In MIDI CHANNEL mode , press STEP +or STEP-button to select desired channel. The LCD shows
CH:XX.MIDI CHANNEL lapse if the indicator close to PATCH button is lit
21. FULL ON button
Press to make 1~8 channels full intensity and STAND BY is not effective.
22. SHIFT button
This button is valid only used with other function button
23. LOOP button
In CHASE mode, press this button to enter LOOP CHASE mode and define present pattern as the 1 st
pattern run by LOOP, the LCD shows XX:LP, press this button again to add the pattern (showing XX)to the
patterns run by LOOP. Up to 100 patterns can be run by LOOP, if over 100 patterns, the LCD shows XX:FL,
if the LOOP button is not pressed within 10 seconds the LCD shows XX:CL, the present pattern is XX, press
LOOP button, the LCD turns to XX:LP, now the patterns are ready to be added to the patterns run by LOOP.
SHIFT+LOOP EXIT button
Press SHIFT+LOOP EXIT together to leave LOOP CHASE mode.
24. CHASE button
Press to enter auto chase mode, the matching point in LCD is lit, In this mode, the chasing speed is
controlled by the SPEED knob and the pattern is controlled by the LEVE knob.
SHIFT+SUDIO button
Press SHIFT+AUDIO together to enter audio chase mode .the matching point in the LCD is lit
25. TAP SYNC button
In CHASE mode, press this button to enter TAP SYNC chase mode, the matching point in the LCD is lit., In
this mode, the interval of the last two pressing on TA SYNC button is set to step time . single pressing is
invalid , To leave this mode turn the SPEED knob to enter auto chase mode.
SHIFT+MANUAL STEP button
Press SHIFT+MANUAL STEP together to enter manual chase mode. the matching point in the LCD is lit. In
this mode, press STEP+ or STEP – to execute the patterns.
26. STAND BY button
Press to enter or leave STAND BY mode. In STAND BY mode, the indicator close to this button is flashing.
Channel fader , LATCH button and the master level generate by present pattern are turned off, FLASH
button level remains.
SHIFT+MANUAL button
Press SHFIT+MANUAL together to enter MANUAL mode, the matching point it LCD is lit and the LCD
shows the MASTER fader with 000 to 100.