Mayline Mobile Lite - Manual (Page 4)

(4)
Anti−Tip Track
Track
Track
STEP 2.
Layout all track (use carriage to affirm track
spacing by rolling carriage on loose track).
The track closest to the wall will be no less
than 1 1/2" from the rear edge of track to the
wall. On a single section carriage, the In-Track
AntI-Tip will be the rear track. On a two section
carriage, the In-Track Anti-Tip will be the
center track. Review the layout determining
where the anti-tip track will lie. Position the
track in place.
STEP 3.
Verify you will end up with 1 1/2" wall clearance
on the track run when system complete.
STEP 4.
When wall spacing has been met and the
carriage moves freely the length of the track
run, proceed to install the anti-tip track.
#12 X 3/4"
TEK SCREW
HILTI TZ 3/8X3
STATIC BASE
ANCHOR BRACKET
STATIC BASE
MLFANTITIP INSTALLATION
TRACK INSTALLATION:
STEP 1.
If included: Assemble one stationary unit at
the end of the track run per layout. Use
stationary shelving to assist in aligning track
and mobile carriage. If the stationary
shelving is installed on a fixed base you
must install the MLFANTITIP to the fixed
base.
SAMPLE LAYOUT:
Spacing From Wall 1
1
2
"
Track placed touching
stationary shelving