Mayline Mobile Lite - Manual (Page 2)

MOBILE LITE SYSTEM INSTALLATION
Kwik-File recommends the removal of all carpet and padding prior to installing Mobile Lite. We suggest
that carpet be removed the length and width of each track. Product performs best when installed on
concrete or tile. NOTE: Kwik-File cannot assure proper leveling if track is installed on low-pile
carpet.
* Read all instructions before attempting assembly.
* Check floor plan layout. Measure and mark floor for intended
layout, preplan exact location of all units with regards to columns,
lights, windows and obstructions.
GENERAL NOTES:
1. Installation of the in-track anti-tip track begins with the floor plan layout . It is imperative for the
proper operation of this system that the tracks be parallel and square. On a two track system, the
in-track anti-tip is the rear track. On a three or more track system, the anti-tip track is the second (from
the front) track.
2. The carriage with the anti-tip guide is designed to be inserted into the track after the track is in the
approximate location, but prior to completely securing it to the floor. This will eliminate the need to
disassemble the guide from the carriage.
3. The carriage is shipped completely assembled, however if the anti-tip guide assembly cannot be
inserted into the track it is possible to remove and reinstall the mount assembly. Care must be taken to
properly place the mount tightly to the channel and angle of the carriage.
4. Required tools:
- Hammer drill (cement drill bit provided)
- Drill with Phillips screw adapter
- Flat and Phillips screwdriver
- 9/16" socket
- 1-1/16" thin wall socket
- 3/4" socket
- Level
- Chalk line
- Measuring tape
- #2 Phillips driver bit
- Hammer
MFTA TRACK
ANTI-TIP GUIDE
ATTACHED WITH (2)
1/4-20 X 3/4" BOLTS
(2)
Detail of Anti-Tip Guide