Mayline RGE - Manual (Page 5)

5
Important Information
Danger: Do not operate the control unit in a potentially explosive atmosphere
Danger: In the event of a fault (motor or component), whenever the desktop attempts to adjust the height
it may move slightly before the safety cut-out is triggered. Please note there is a potential risk of pinching in
this case.
Danger: Intelligent system protection is not enabled during all resets. Please note there is a potential risk of
pinching in this case.
Danger: This device is not intended for use by individuals with limited physical, sensory or mental abilities
or with lack of experience and/or lack of expertise, unless they are supervised by a person responsible for
their safety or have received instructions from that person how to use the control unit.
Danger: Children must be supervised at all times to ensure that they do not play with the control
unit/table.
Danger: If the power cord is damaged, it must be replaced by the manufacturer, customer service or similar
qualified person in order to prevent any risks.
Note: Only clean the handset/control unit with a dry or slightly moist cloth. Before cleaning, you must
always unplug the power cord.
Danger: The table may not be used to lift people.
Danger: The table may not be structurally or technically altered or modified in any way. During repair or
maintenance work, the power cable must be disconnected from the power outlet.
Danger: The table is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities or by individuals lacking the knowledge or experience to operate the table, unless
monitored or otherwise instructed regarding its use by a person responsible for their wellbeing. Children
should be monitored at all times to prevent them from playing with the table.
Danger: Any changes or modifications to the electric control unit are strictly forbidden and voids warranty!
1.2 User Information
The table is suitable for household and public occupancies use.
The motors may only be used continuously for 1 minute at a time, after which they must be left inactive for
nine minutes before they can be used again. The control unit regulates this automatically.
FOR COMMERCIAL AND HOUSEHOLD USE
This furnishing has not been evaluated for flammability or cigarette ignition resistance.
1.3 Before You Start
Make sure that there is nothing blocking the travel of the desk in the space where it will operate.
Before first use, the control unit must register the lowest point of elevation (reset).
To do this, simply lower the table to the lowest position by pressing and holding the “Down” button until
the table reaches the lowest position. The control unit has now registered the lowest elevation and is ready
to use.