Mayline RGE - Manual (Page 12)

12
5.4 Resetting After Replacing Control Unit
If a control unit is replaced or switched, the new control unit must first be reset to establish the lowest
point of the table. To do this, press and hold the “Up” and “Down” buttons simultaneously for at least 7
seconds and then press “Down” to bring the table to the lowest point. The control unit will now have
registered the lowest point and the table is ready for use. Verify correct functionality by elevating the table
to the highest point and then back to the lowest point.
The control unit is equipped with safety features; the intermittency function and the overheating
protection and memory function.
• Intermittency function – The intermittency factor of the control unit is 10%, meaning it
can be operated for 1 minute after which it must remain inactive for 9 minutes. If the
one-minute limitation is exceeded, the table will become inoperable until the control box
resets automatically.
• Overheating protection – The table will become inoperable if the overheating protection is
triggered and will return to operation automatically once the heat has dissipated
sufficiently.
• Memory function – The control unit will retain information regarding the elevation of the
table at all times. This information will remain stored even in case of power failure or if
the power cable is disconnected from the power outlet.
Soft start – Progressive acceleration allows for soft starts and stops.
Speed – the speed of the table varies with load.