beautypg.com

Operating safety service safety – Marshalltown Truss Screed User Manual

Page 6

background image

6

OPERATIONS

SECTION 1

Familiarity and proper training are required for the safe operation of this equipment. Equipment operated improperly or by untrained per-
sonnel can damage equipment and could be dangerous. Read the operating instructions contained in this manual to familiarize yourself
with the location and proper use of all the controls.

DO NOT operate this machine until you have read the operating and safety instructions. Operate the machine in accordance with the
manufacturer’s instructions.

ALWAYS inspect your screed upon arrival for damage or tampering that can sometimes occur during shipping. If damage is found, file a
claim with your carrier immediately!! Mark freight bill of lading as “damaged shipment”.

NEVER allow untrained personnel to operate your truss screed. Individuals who operate this screed should have adequate training in
operating procedures.

DO NOT attempt to fill hydraulic(winch) tanks while machine is running.

NEVER use over-the-counter hardware to replace manufacturers hardware. Contact MARSHALLTOWN Customer Service
Department for information regarding replacement parts. 800-888-0127

HAZARD: When operating machines with gas engines in confined areas, the fumes must be ventilated. Improper ventilation could lead
to serious health problems or even death.

ALWAYS be aware of HOT components on this machine, such as, hydraulic components.

OPERATING SAFETY

SERVICE SAFETY

DO NOT attempt to clean or service screed while machine is running.

DO NOT use gasoline, other fuels, or any flammable solvent to clean parts, especially in enclosed areas. Fumes from fuels and sol-
vents can cause serious health problems if you are exposed to them over an extended period of time.

ALWAYS disconnect spark plug before servicing engine to prevent accidental start-up.

ALWAYS wear adequate hearing protection while running your truss screed.

The information above was acquired through vibration and sound analysis. A certified sound and vibration technician was used to test
several of our products. All of the data collected was measured according to OSHA standards ISO 3744. If there are any questions on
this particular subject, contact MARSHALLTOWN Customer Service. 800-888-0127

AVERAGE EQUIVALENT

SOUND PRESSURE LEVEL

SOUND PRESSURE LEVEL

AT OPERATOR’S EAR

EQUIVALENT SOUND

POWER LEVEL

89DB (A)

96DB (A)

106DB (A)