Marshalltown Truss Screed - Manual (Page 13)

13
To attach the winch cables properly, adhere to the following instructions.
• Take the cable and go around the last form stake. Make sure that you go underneath the form.
• Attach the cable hook to the next form stake from the end.
DETERMINING LEFT AND RIGHT OF
The following illustration shows all the key information
on how to determine the left and right and the
front and rear of a screed section.
Note the circle with the product stamp.
This is probably the easiest way to
determine the left and right sides of
the screed assembly. The right side
has the model number and the a 5-
digit product stamp. The left hand
side is only stamped with an “L”.
Also the front of the screed is
determined by the two screed blades
mounted back-to-back. The rear of
the screed has only one bullfloat
blade.
OPERATIONS
SECTION 1
A
C
D
D
ATTACHING WINCHES TO FORM STAKES
The figure below illustrates the proper way to attach the winch cables to the form stakes. This is the only way that the cables should be
attached. If the cables are not attached properly, the cables could snap loose causing severe injury to finishing personnel surrounding
the screed.