M ag.layers, Mechanical, Electrical – Mag Layers USA MSCDRB-1507 User Manual
Page 4
MECHANICAL
TEST ITEM
SPECIFICATION
Resistance to
There shall be
Temperature profile of reflow soldering
Soldering heat
no damage or
(reflow soldering)
problems.
The specimen shall be passed through the reflow oven with the
condition shown in the above profile for 1 time.
The specimen shall be stored at standard atmospheric conditions
for 1 hour, after which the measurement shall be made.
ELECTRICAL
TEST ITEM
SPECIFICATION
TEST DETAILS
Dielectric
There shall be
AC 100V voltage shall be applied for 1 minute acrosset the top
withstand
no other
surface and the terminal of this sample
voltage
damage or
problems.
Temperature
△L/L20℃≦
±10%
The test shall be performed after the sample has stabilized in
characteristics
0～2000 ppm/℃
an ambient temperature of -20 to +85℃,and the value
calculated based on the value applicable in a normal
temperature and narmal humidity shall be △L/L20℃≦
±10%.
Page-4/8
MSCDB-1507-SERIES
Sodering temperature (
℃
)
soldering
(Peak temperature 260±3℃ 10 sec
Slow cooling
(Stored at room
temperature)
30 sec Min
(230
+0
℃)
300
250
200
150
100
50
2 min
10
sec.
2 min. or more
Pre-heating
150 ~ 180℃
M AG.LAYERS