Loadstar Sensors DQ-4000 - Manual (Page 14)

DQ-4000 DQ-4000 User's Guide
Page: 14 / 21
P/N : 033-02061 Rev. 1
3.5 Terminal command line operation
Once you are connected to the DQ-4000 via HyperTerminal or another terminal emulation
program, press [Enter] several times. You should get an “A” returned on your PC monitor
screen for every [Enter] pressed. You may now issue ASCII commands to the DQ-4000, to
remotely monitor and control the attached sensors.
You may press “?” at any time to see the available command list. The available commands will
be described in detail in the next chapter.
The CONF lists additional commands available to configure the interface. CAUTION: Please use
the CONF commands only when you are very familiar with the operations of the DQ-4000,
otherwise the DQ-4000 might display erroneous weight.
The SETTINGS lists the settings for currently selected channel(s). If an individual channel was
selected using S1, S2, S3 or S4 command, the displayed values apply to the currently selected
sensor. If all channels were selected using S0 command, the displayed values apply to the DQ-
4000 as a whole.