Lightforce LED 215 - Manual (Page 2)

LIGHTFORCE AUSTRALIA PTY LTD • 28 Orsmond Street, Hindmarsh SA 5007 Australia • www.lightforce.com | email: [email protected]
Australia: Tel: 08 8440 0888 | Fax: 08 8346 0504 • Int’l: Tel: +618 8440 0888 | Fax: +618 8346 0504
All logos and images are subject to relevant trademark and copyright protection LIGHTFORCE Pty Ltd | © July 2014 • Data and specifications contained maybe subject to change without notice.
LIGHTFORCE Australia Pty Ltd shall not be liable for damage, malfunction, failure resulting from accident, misuse, misapplication, unauthorised repair, neglect, modification, unauthorised or non standard replacement parts,
accessories, bulbs, batteries or voltage or operation of the product beyond its technical and or environmental specification.
ELECTRICAL CONNECTIONS:
The LED215 is fitted with a waterproof 4 pin electrical connector, included is the mating connector fitted with short lengths of cable
for integration with an existing wiring harness.
The LED215 is also fitted with dual LED positioning lights located on each side of the housing, for the positioning LEDs to activate
they must first be connected to the park light or low beam circuit.
If using the optional wiring harness (Part number CBLFDLH4) follow the installation instructions included with the harness.
If using an existing wiring harness the included connector needs to be fitted directly to your existing driving light harness and park
or low beam light circuit.
CONNECTOR WIRE COLOUR IDENIFICATION
1. Black: Negative - Connect to negative (earth) wire on harness
2. Red: Positive – Connect to positive wire on harness
3. Blue: Negative - LED positing lights, connect to negative park or low beam light circuit
4. Yellow: Positive - LED positing lights, connect to positive park or low beam light circuit
LED215.indd 2 31/07/2014 3:56:59 PM