Lenze EPM−H507 - Manual (Page 71)

Commissioning
Project transfer to the operating unit
Disconnecting from the PC
5
l
71 EDBPM−H505 DE/EN/FR 6.1
What to do
A Switch on the PC and start the »HMI
Designer« planning tool.
B Switch on the supply voltage for the
operating unit.
0
1
2
Port : NET
Driver : CAN Lenze M
Ver
: 1.12
Addr : NO ADDRESS
Error : RESET
PROG
ESC
TRANS
PAGE
H505 TRANSFER PAGE
Main BOOT and RAM check: OK
Main FIRMWARE check
: OK
*** *** WAITING FOR DOWNLOAD FROM MSP
3
The device is being initialised.
C After initialisation, select the system
page. For this purpose, touch the display
at the corners
l top right 0 and bottom left 1 or
l top left 2 and bottom right 3.
The first corner to be touched must not
contain a selectable field.
The system page appears.
D Touch the TRANS PAGE" field.
The transfer page appears.
When WAITING FOR DOWNLOAD
FROM MSP is displayed, the
operating unit is ready to receive
data from the PC.
E Transfer the desired project from the
»HMI Designer« into the operating unit.
^ HMI Designer − Getting started"
PROGRAMMING MODE" is displayed during the download.
F After download is completed, the operating unit is ready for operation and can exchange
data with the connected nodes by the system bus. The project is stored after disconnection
from the supply voltage.
5.2.3 Disconnecting from the PC
1. Switch off the PC.
2. Switch off the supply voltage for the operating unit.
3. Remove the EPZ−H110 download cable from the operating unit and the PC.
4. Switch on the supply voltage for the operating unit.
The operating unit is now ready for operation.