Lenze E82ZAFPC010 - Manual (Page 7)

About this documentation
Conventions used
1
l
7 EDS82ZAFPC010 EN 4.0
1.2 Conventions used
This documentation uses the following conventions to distinguish between different
types of information:
Type of information Identification Examples/notes
Spelling of numbers
Decimal separator Point In general, the decimal point is used.
For instance: 1234.56
Decimal Standard notation For example: 1234
Hexadecimal 0x[0 ... 9, A ... F] For example: 0x60F4
Binary
l Nibble
In quotation marks
Point
For example: ´100´
For example: ´0110.0100´
Text
Program name » « PC software
For example: »Engineer«, »Global Drive
Control« (GDC)
Icons
Page reference ^ Reference to another page with additional
information
For instance:
^ 16 = see page 16
1.3 Terminology used
Term Meaning
PROFIBUS The term stands for the PROFIBUS−DP variant according to IEC 61158/IEC 61784. A
different PROFIBUS variant is not described in this manual.
Standard device Lenze controllers/frequency inverters for which the function module can be used.
^ 11
Controller
Frequency inverter
Master PROFIBUS station which takes over the master function in the fieldbus system.
Slave PROFIBUS station which acts as a slave in the fieldbus system.
Code "Container" for one or more parameters which can be used to parameterise or
monitor the controller.
Subcode If a code contains more than one parameter, these parameters are stored in
"subcodes".
In this documentation, a slash "/" is used as a separator when specifying a code and
its subcode (e.g. "C00118/3").
POW Process output data word
PIW Process input data word