Leica Biosystems SP9000 - Manual (Page 25)

25 Leica SP 9000 – Automatic knife sharpener
Should the occasion ever arise, the Leica Knife Sharpener can be re-
conditioned at the Leica factory in Nussloch, Germany or at many of the
Leica Microsystems Technical Service Centres worldwide. This is a cus-
tomer service provided at a nominal charge.
1 . CLEANING :
Plastic cover and outside enamelled surfaces should be kept clean. Use only
warm water and detergent. Sponge out and wipe dry the catch-basin on the
hone table after each sharpening session. Knife holder, knife holder shaft
and exposed fittings are non-corrosive and require no attention other than
normal cleaning.
2. LUBRICATION:
Lubricate two slide rods approximately once each month, depending on how
extensively it is used.
Reconditioning
Leica Messerschleifdienst
Leica Biosystems Nussloch GmbH
Heidelberger Straße 17-19
D-69226 Nußloch
Telefon: (0 62 24) 143-0
Telefax: (0 62 24) 143-200
7. Redressing hone glass plates