Labnet 222DS Benchtop Shaking Incubator User Manual - Manual (Page 8)

BENCHTOP SHAKING INCUBATOR 222DS USER'S MANUAL
Page 8
 If you want to use the shaking incubator without shaking - set OFF on display. You
get OFF function on display, when you rotate encoder under 20 RPM or above 300
RPM.
 Press encoder knob.
 Time signal light blinks. With rotating encoder clockwise (+) or counter-clockwise (-),
set time to desired value from 1 min to 99 h:
70.3
 70h 30 min
1.55
 1h 55 min
0.43
 43 min
0.01
 1 min
POWER
 If you want to set Time to hold (continued operation) - set HLd on display. You get
HLd function on display, when you rotate encoder under 0.01 min or above 99.0 h.
 Press START/STOP key once to exit the changing of parameters. You are now in
starting mode. Only signal light of the last changed parameter shines.
Note: You always change the parameter, whose signal light blinks - temperature,
speed or time. You can always change one, two or three parameters. To exit
the changing of parameters, always press START/STOP key once.
 Press START/STOP key to start the operation.
 Run signal light shines. Shaking incubator counts down the time from set value.
You can move between the values of time and speed during the operation, by pressing the
encoder. These two values are shown alternately on bottom display
.
POWER