Labnet 222DS Benchtop Shaking Incubator User Manual - Manual (Page 5)

BENCHTOP SHAKING INCUBATOR 222DS USER'S MANUAL
Page 5
3.3
ATTACHING POWER CORD
Fit the mains cord, which is included in the delivery, into the mains receptacle. Connect the
other end of the cord to a grounded wall socket.
3.4
ATTACHING SHAKING PLATFORMS
The SHAKING INCUBATOR has a variety of platforms available, to meet most of the shaking
needs. These platforms mount to the shakers via four mounting platforms which easily plug
into four rubber mounting points on the top of the shaking incubator.
3.5
STARTING UP
3.5.1 STARTING UP CHECK LIST
-
Unpack and place the device as specified in previous paragraphs.
- Open the lid and fix shaking platform with test samples on the plate.
- Close the lid cover.
- Switch on the device by the ON/OFF switch on the front panel.
Light in the switch indicates that the power is on.
- Check all the parameters and set new parameters values if necessary. Please refer to
procedures described in next chapters.
3.6
GENERAL SAFETY RECOMMENDATIONS
Before any installation read this User’s Manual.
-
Before cleaning disconnect the device from mains power supply. Device could be
cleaned with a soft, lightly wet cloth. Don’t use cleaners or liquids on aerosol basis.
- Do not use the device nearby water sources. Take care, that water will not drop in the
device; especially by cleaning procedures.
- Do not use device in aggressive atmosphere.
NOTE:
In case that device is not functioning properly, even if you have exactly followed
instructions described in User’s Manual, you are allowed to use only those commands
and procedures, which are allowed by User’s Manual. Use of any other commands and
procedure’s adjustments could result in device destruction or longer service repair
time.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
Do not shake inflammable or explosive samples!