Koolance EX2-755-R - Manual (Page 13)

18 19 User Manual
Liquid Coolers
You should now install the liquid coolers (CPU, GPU, Hard
Drive, etc.) to your hardware before continuing this User Manual.
Please refer to your cooler kit’s individual installation instructions,
then continue on to the next section.
Chapter
3
Filling & Maintenance
WARNING : The cooling system’s pump can not be run dry for any
period of time. Never power-on the computer or cooling system without
sufficient liquid in the reservoir. Dry-running (and thereby damaging
the pump) is not covered under the Koolance product warranty.
!
Testing & Filling
Filling & Maintenance
Once all the water blocks have been connected,
the system can be filled with coolant. The fill port is
located on top of the reservoir. Remove the large
slot-headed screw (with a screwdriver or large
coin).
WARNING : Most coolants are electrically conductive. Use caution
when filling the system, and keep all liquids away from electronics and
power cables. In case of emergency during installation, immediately
unplug the primary AC power cable. Dry the system thoroughly before
proceeding.
!
CAUTION : When filling, the
cooling system should be higher
than all other liquid components
to avoid spillage.
!
When empty, the cooling unit should
be placed above all other water
blocks when adding liquid. Otherwise,
coolant can be forced out the fill port
instead of into the hoses.
Slowly fill the system. To maintain the product warranty, use only Koolance
approved coolant. Many alternative liquids and additives can cause permanent
damage to the cooling unit (through chemical reaction, corrosion, biological growth,
thermal expansion, viscosity, etc.).
The liquid coolant should be filled to about 6mm (1/4”) from the reservoir’s top. Do
not overfill.