Koolance CPU-300-V13 - Manual (Page 2)

For AMD Athlon/XP processors, the left or right receptacles will be used,
depending on which direction the CPU socket faces in relation to the cooler.
For Intel P-4, Xeon, AMD Athlon 64, or Opteron processors, use the center
hole.
Screw alignment
for right-side AMD
Athlon/XP
processors
Screw alignment for
left-side AMD
Athlon/XP
processors
Screw alignment
for P-4/Xeon and
Athlon 64/Opteron
processors
With the bracket properly aligned, insert and slowly twist the tension screw
until it can no longer be tightened. Over-tightening is prevented by a
ratcheting action.
3 center holes
correspond with
different CPU
socket positions
Due to different contact pressure requirements, two tension screws are
included with the CPU-300. Use the
BLUE screw for “open die” processors,
such as: AMD Athlon/XP or Intel P-III. Use the BLACK screw for processors
with heat spreaders, such as: Intel P-4, Xeon, or AMD 64/Opteron.
Intel P-4/Xeon & AMD 64/
Opteron Black Screw
AMD Athlon/XP Blue Screw
CAUTION: Installing the incorrect tension screw for your processor
may result in hardware damage.
!
CAUTION: Installing the tension screw into the wrong cooler
receptacle can cause insufficient cooler contact, and may result in
hardware damage.
!