KD Scientific 910 OEM Pump - Manual (Page 10)

11
KDS Milliliter OEM Module
11
Operation
GETTING STARTED
Plug one end of the power cable into P8 connection on board. Connect communication
cable from PC to J1 connector. Refer to page 6 of this manual to reference the board
connections.
WORKING WITH THE PUMP
The safest way to use the “ML” OEM Pump Module is in the volume dispense mode. The
pump will automatically stop when target volume is dispensed.
Enable must be tied to ground (Hardwire P7-3 to P7-4 or connect through switch).
CHECK SYRINGE OFTEN
The “mL” OEM Pump Module will shut itself off when the syringe is empty or is otherwise
overloaded. Although this presents no hazard to the user or the pump, it is prudent to check
the syringe from time to time.
MAINTENANCE
Keep the “mL” OEM Pump Module clean and dry. Avoid liquid spills that may find their
way into the electronics.
A small tube of grease is provided for periodic lubrication of the lead screw. It is important
to keep the lead screw clean and lubricated.
To clean the exterior surfaces above the base plate, use a lint-free cloth to remove loose
dust. For more efficient cleaning, use a soft cloth dampened with water or an aqueous solu-
tion of 75% isopropyl alcohol.
If the pump does not work properly, contact KD Scientific for appropriate instructions.