KD Scientific Centrifan PE - Manual (Page 32)

Chapter 4
4-2 Centrifan TM PE Personal Evaporator
Figure 4-1: Remove Nut, Fan, and Two Fittings to Free Liner for Cleaning
4.1.3 Routine Inspection
On a periodic basis, the following activities should be performed:
a) Inspect the tubing between the evaporator module and the cold trap. If the tubing is
cracked, deformed or solid material is deposited inside the tubing, replace the tubing
b) Inspect the inert gas supply tubing (or the jumper tube). If the tubing is cracked,
deformed or solid material is deposited inside the tubing, replace the tubing.
c) Inspect the rotor components for signs of damage. Replace as required.
d) Replace the solvent in the cold trap.
4.2 Troubleshooting
Note: There are no components inside the system that require any user
interaction. If the system does not operate satisfactorily, please contact the
manufacturer or your local agent.