KD Scientific Centrifan PE - Manual (Page 29)

Operation
Centrifan TM PE Personal Evaporator 3-7
is counting down the minutes, a lighted dot will blink in the top left corner of the
display.
c) To interrupt the evaporation the timer module can be deactivated by holding down
the SET button for 1 second. The unit will beep and display End and OFF showing
that the time interval has been deleted.
Note: To immediately shut off and stop the Centrifan TM , just open the lid.
3.5.3 Switching between Manual and Timer Modes
The user can switch between the two timer module modes, manual and timer, by
following the steps below:
a) Press and hold the SET button for about 8 seconds at which time the display will
show the characters Ut.
b) Use the ▲ or ▼buttons to cycle through the four parameters, “Ut”, “toP”, “bc”, and
“MAn”. Press the buttons until “MAn” is displayed.
c) Press SET to view the current value of the “MAn” parameter (ON=manual mode,
OFF=timer mode).
d) Use the ▲ or ▼buttons to toggle between ON and OFF.
e) Press SET to lock in the parameter.
f) Press the SET and ▼buttons simultaneously to quit the programming mode or wait
one minute and it will quit automatically.