KD Scientific Centrifan PE - Manual (Page 3)

Centrifan TM PE Personal Evaporator iii
Warnings and Safety Precautions
The following precautions should be followed to minimize the possibility of personal injury
and/or damage to property while using the Centrifan
TM
PE.
1. Maintain a Well-Ventilated Laboratory
Volatile organic solvents may be used in the system. Ensure that the laboratory is
well ventilated so that a buildup of vaporized solvent cannot occur.
2. Ensure That Solvent Vapor Is Not Allowed To Escape Into The Laboratory
Any organic solvent vapor must be vented to an external venting system so that it
cannot collect in the laboratory.
3. Avoid Open Flames And Sparks
Volatile organic solvents may be used in the system. Do not use an open flame in
the laboratory and do not install any equipment that can cause sparks or other
ignition sources in proximity to the instrument.
4. The System Must be Plugged Into A Grounded Power Receptacle
Ensure that all parts of the system are properly grounded. Do not attempt to bypass
the earth ground connection. A serious shock hazard could result.
5. Treat All Samples And Solvents As If They May Contain Hazardous Substances
Or Transmit Disease
The samples and/or solvents that are handled by the system may contain
compounds that could present a hazard to the operator of the instrument. Take all
precautions to ensure that they do not come into contact with the skin or eyes. A sink
and eyewash should be located in the laboratory. In the event of an accident, wash
the affected part with copious quantities of water and seek medical assistance. If you
are handling biological/clinical samples, treat them in accordance with the infectious
disease control program of your institution.
6. Do Not Disassemble Any Part Of The Instrument Which Requires A Tool
There are no user serviceable parts inside the base of the instrument enclosure or
under the heater assembly in the lid. It is not necessary to remove any enclosure
screws to perform the cleaning procedures envisaged for the user of the instrument.
7. Wear Protective Eyewear
Reagents used in the system can damage your eyes. Protective eyeware should be
worn by the operator. The system should be used in proximity to an eyewash sink. If
any solvents or chemicals splash on the skin or eyes, immediately rinse the affected
parts in the sink. Obtain medical help as needed.