Kargo Master Pro II Service Body (70020) - Manual (Page 4)

SRV-BODY 12_1.1
NOTE: If it is not possible to attach
the included rear leg mounts to your
service body back panel because the
panel is plastic or because the tail
lights or box lock handle are in the
way, please see OPTIONAL
MOUNTING METHODS on the back
page. These options require
accessory mount kit #70060
purchased separately.
LBS.
REAR MOUNTS
ATTACHING AREA
7"
VARIABLE HEIGHT
ADJUSTMENT
AREA
77.5" - 79"
GOOP APPLICATION
Apply a healthy air tight bead of goop
around
every swaged joint as shown, to
prevent moisture from leaking into and out
of the joint. If this is not done properly, the
inside surface of the tubes can rust and
rusty water can leak out. Maintain this
joint seal throughout the life of your rack.
Swaged joint & holes
Smooth goop at swaged joint & holes
GOOP
GOOP
BEFORE YOU BEGIN, PLEASE VERIFY THAT THIS RACK WILL FIT YOUR SERVICE BODY.
#1- Side Channel kit 78010 will fit an 8ft. body mounted on an extended cab chassis. Side Channel kit 78000
will fit an 8ft. body mounted on a standard cab chassis. Side Channel kit 79010 will fit a 9ft. body mounted on an
extended cab chassis, or an 11 ft. body mounted on a standard cab chassis. Side Channel kit 79000 will fit a 9ft.
body mounted on a standard cab chassis.
#2- The "bulkhead" is the panel that is the front of the service body. Measure the distance from the top of the
bulkhead to the top of the truck's cab. This distance should be in the range of 15" to 22".
#3- Standard mounting is on rear panel. Check to ensure that the rear panel of the service body is free of
taillights or other obstructions (inside or out) in the area where the rear legs of the rack bolt to the body.
Consult sketch below: