JUMO 902880 Level and Temperature Probe for Utility Vehicles as Well as Construction and Agricultural Machinery Data Sheet - Manual

Data sheet 90.2880 Page 1/3
JUMO GmbH & Co. KG
Delivery address: Mackenrodtstraße 14,
36039 Fulda, Germany
Postal address: 36035 Fulda, Germany
Phone: +49 661 6003-0
Fax: +49 661 6003-607
E-mail: [email protected]
Internet: www.jumo.net
JUMO Instrument Co. Ltd.
JUMO House
Temple Bank, Riverway
Harlow - Essex CM20 2DY, UK
Phone: +44 1279 63 55 33
Fax:
+44 1279 63 52 62
E-mail: [email protected]
Internet: www.jumo.co.uk
JUMO Process Control, Inc.
8 Technology Boulevard
Canastota, NY 13032, USA
Phone:
315-697-JUMO
1-800-554-JUMO
Fax: 315-697-5867
E-mail: [email protected]
Internet: www.jumo.us
Level and temperature probes
for utility vehicles as well as construction
and agricultural machinery
„ Temperature range from -40 to +140 °C
„ As level or combined level and temperature probes
„ Connection line: cross-linked polyester
„ Installation position: standing or suspended
„ Measuring path of 50 mm or 62 mm
For optimum motor or gear operation, several parameters must be continuously monitored and
corrected in the event of deviations.
The oil level and the oil temperature are two of these parameters.
The combined level and temperature probe supports the vehicle diagnosis of modern utility ve-
hicles, construction and agricultural machinery. This level probe operating according to the hot-
wire principle allows to determine the filling level of gear or motor oil throughout a measuring
path of up to 100 mm. Only the filling level monitoring will ensure that the motor does not oper-
ate with excessive or insufficient oil. This will prevent damage to the motor.
The level probe can also be provided with an additional temperature sensor. The level and tem-
perature probe is equipped with a Pt1000 temperature sensor as per DIN EN 60751, cl. B in 2-
wire circuit. The design with Pt100 or Pt500 temperature sensors as well as NTC and semi-con-
ductors are also possible.
The voltage signal transmitted by the hot-wire and the resistance signal from the temperature
sensor are separately transmitted to the vehicle electronics for evaluation.
Depending on the customer requirements, the housing can be made of stainless steel, steel or
heavy-duty plastics.
The level and temperature probe is designed for a temperature range from -40 to +140 °C in
permanent operation.
Technical Data
Connection Cable ends stripped bare,
with connector DIN 72585 (quarter-turn type connector) or as per customer requirements
Cable Cross-linked polyester, ambient temperature -40 to +150 °C
Process connection Screw connection M 24x1.5 or as desired by the customer
Thermowell Stainless steel or galvanized steel (heavy-duty plastics on request)
Temperature probe Pt1000 DIN EN 60751, cl. B, 2-wire-circuit
Level sensor Hot-wire principle, ±3 mm tolerance
Measuring path 50 mm or 62 mm (different measuring paths on request)
Installation position standing (process connection in the media)
suspended (process connection not in the media)
2009-10-13/00523287