JULABO FD200 Flow-Through Cooler - Manual (Page 18)

Cleaning / repairing the unit
18
FT900
 The ventilation grid (7) is detached by unscrewing the four
mouting screws (FT900).
 Clean the ribbed condensor with a vacuum cleaner.
 Replace the hood or the ventilation grid.
 Switch on the unit.
Clean the outside of the unit using a wet cloth and low surface
tension water.
Repairs
Before asking for a service technician or returning a JULABO
instrument for repair, please contact an authorized JULABO
service station.
When returning the unit:
 Clean the unit in order to avoid any harm to the service
personnel.
 Attach a short fault description.
 During transport the unit has to stand upright. Mark the
packing correspondingly.
 When returning a unit, take care of careful and adequate
packing.
 JULABO is not responsible for damages that might occur
from insufficient packing.