Johnson Systems DPC-24-3000 Series Digital Pack Controller - Manual (Page 19)

www.johnsonsystems.com 19
K:XXX>XX Press MENU ( ) to modify the fifth hard-key character.
K:XXXX>X Press EXECUTE to advance to the sixth hard-key character.
K:XXXX>X Press MENU ( ) to modify the sixth hard-key character.
Press ESCAPE to exit the menu and save the desired hard-key code.
Press RESET to exit the menu without saving.
The menu will automatically timeout after 2 minutes of inactivity and save.
NOTE: Be sure to record and file the hard-key code on page 23 for future reference.
26. SERIAL# View the microcontroller’s unique six-character silicone serial number.
XXXXXX Shows the unique six-character serial number
27. VERSION View the microcontroller’s software version.
VER X.X Shows the microcontroller’s software version.
28. EEPROM View the type of EEPROM memory module plugged in.
All DPC-12 and DPC-24 control modules are equipped with a removable EEPROM
memory module. The EEPROM memory module inserts into the PORT1 connector
located on the upper left-hand side of the board, and may be removed for safe
storage.
The EEPROM type is programmed for parameter (P) or firmware (F) operation. A
parameter EEPROM is used to backup all of the current configuration settings. A
firmware EEPROM is used to update the current firmware version running on the
DPC-24/12 microcontroller to the firmware version saved on the EEPROM.
The EEPROM memory module supplied with all DPC-12 and DPC-24 control
modules is a parameter type with all of the factory default configuration settings saved
onto it before shipping.
DPC-12-P Indicates the EEPROM memory module is for a DPC-12 microcontroller.
DPC-24-P Indicates the EEPROM memory module is for a DPC-24 microcontroller.
DPC-24-P Indicates the EEPROM type is programmed for parameter (P) operation.
XXXXXX Press EXECUTE to display the silicone serial number parameter.
DISABLED Press EXECUTE and menu feature is disabled for factory use only.
DPC-24-F Indicates the EEPROM type is programmed for firmware (F) operation.
VER X.X Press EXECUTE to display the version (VER) of the firmware.
DISABLED Press EXECUTE and menu feature is disabled for factory use only.
NONE! Indicates the EEPROM memory module is not installed.
29. FW-LOAD Load new firmware into the microcontroller via the EEPROM memory module.
If a firmware update is required, Johnson Systems Inc. may supply an EEPROM
memory module with the latest firmware version. The firmware EEPROM memory
module can be inserted into PORT1 connector located on the upper left-hand side of
the board, and the firmware can be loaded into the microcontroller.
Press EXECUTE to enter the menu.
DISABLED This menu is disabled to help prevent inadvertent changes. Proceed to enable.
ENABLED Press and hold MENU ( ) and MENU ( ) at the same time for 4-5 seconds.
MEMCHECK Automatically checks the EEPROM memory module for firmware type.
CRC-TEST Automatically does a CRC test on the firmware code in the EEPROM.
>>>>>>>> CRC test in progress.
VER X.X Displays the firmware version on the EEPROM memory module.
UPDATE?? Press EXECUTE to proceed.
SURE ??? Press EXECUTE to proceed.
UPDATING Firmware update in progress.