Hydro-Logic StealthRO100 - Manual (Page 9)

VWHDOWK52
100
™ Setup
(cont)
to the 'off' position as soon as you see water flow from the blue purified water line.
This will pressurize the system and is a good way to make sure that all fittings
and connections are secured properly and that there are no leaks. It is also a good
way to make sure that the automatic shut-off is working properly, meaning the
black drain line is shutting off. If there are problems of any kind please contact
Hydro-Logic directly at 888-426-5644.
1RWH It may take up to 24 hours of running the system for the PPM & pH
of the purified water to stabilize.
Source/Inlet Line (White)
Purified Water Line (Blue)
Waste Water Line (Black)
Upon intial start up of system, slowly turn the source water on until both the
carbon and sediment filters have water in the housings. Next, open source
water up all the way (do not exceed 80 psi). Flush the system for 30-45
minutes when the system is new and/or when you replace your membrane.
This will flush out the food grade preservative in the membrane .
The first time you run water through the system please turn the inline shut-off valve