Hydro-Logic StealthRO100 - Manual (Page 4)

Precautions:
How Does Reverse Osmosis Work?
Product Water Collection Material
Waste Water
Tube
Product Water
Membrane
Feed Channel Spacer
Outer Wrap
Perforated Central
Brine Seal
Source Water
Feed Channel Spacer
Membrane
t Do not install the unit where the source/inlet pressure may be more than 80 psi or there
are excessive water hammer/spike problems. If your inlet pressure is more than 80 psi,
install a 3/8” pressure regulator (HL#10071 see pg. 12), available at your dealer or through
t Protect unit against freezing to prevent cracking of the filter housing and water leakage.
t Keep out of direct sunlight or high intensity lights, which degrade the housing and fittings
over time. For added protection use the Algae Block Sleeve (HL# 26009 see pg. 12) to protect
from sun or lights.
t Do not drop or place heavy objects on top of unit.
t When replacing filter cartridges use the filter wrench to remove housing. Do not use the
wrench to tighten the housings. Hand tighten the housings only. Take care not to over tighten.
t Do not install where leakage or failure may cause damage to property.
Hydro-Logic. If you suspect you may have a problem with water hammer or pressure spikes,
use the high limt pressure gauge (HL#19306 see pg. 13) to determine what your upper
pressure reading is.
System Specifications:
STEALTH-RO200 31035
Hydro-Logic
Part Number
Product Water
Flow Rate
Inlet
Tubing
Size
Product
Tubing
Size
Waste
Tubing
Size
3/8” 1/4” 1/4”
*see page 11 for performance parameters
100 GPD (Gallons Per Day)
4 GPH (Gallons Per Hour)*