beautypg.com

HYDAC HDA 5500-1-2-DC-000 User Manual

Page 18

background image

HDA 5500 User Manual

- 18 -

12.2 Altering the main programming enable
The main programming enable can only be altered when switching on the HDA 5500. If the
HDA 5500 is already in operation, then the supply voltage must first be switched off or the
HDA 5500 must be disconnected from the supply voltage.
Procedure:

When switched off, press both arrow keys simultaneously and hold down.

Switch on or connect the supply voltage and at the same time continue to hold down the
arrow keys for at least 3 s.

MPrG (Main Programming) is displayed.

After approximately 2 s the display changes and the actual setting is displayed:
Free (programming enabled) or Loc (programming disabled).

Within approximately 3 s the setting can be changed to Loc or Free by pressing
the

or

key.

If

or

have not been pressed for approximately 3 s or longer, then the displayed

setting is accepted. If a setting has been changed, then ProG (Programming) is dis-
played for approximately 2 s. This means the changed setting is stored in the HDA 5500.
Afterwards the display returns to normal operation.

3 s

measured value

3 s

Press both arrow

keys simultaneously

and hold down for 3 s

Use

to change setting

Loc

FrEE

= programming disabled

= programming enabled

Display

(release

arrow keys)

2 s

mode

mode

or

Displays

Press both arrow

keys simultaneously

and hold down.

Switch on supply

keys for 3 s)

voltage (hold down

3 s

3 s

Use

to change setting

Loc

FrEE

= programming disabled

= programming enabled

Display

(release

arrow keys)

2 s

mode

mode

or

measured value

Displays

This manual is related to the following products: