HYDAC EDS 300 - Manual (Page 8)

7. Programming enable
The unit has 2 types of programming enable which must both be set to "ON" to change the
settings. The operating programming enable can be set or removed during operation. It
provides protection from unintentional alteration. A programming disable via the main
programming enable has the effect that no change to the settings can be carried out during
operation. This serves, for example, as a safety function or as protection against
unauthorised alterations.
7.1 Altering the operating programming enable
mode mode
3 s
pressure
3 s
press both
arrow keys
simultaneously
and hold down
for 3 s
use or to alter setting,
OFF
ON
= programming disabled
= programming possible
display
(release
arrow keys)
display
7.2 Altering the main programming enable
Switch off supply voltage or disconnect the unit from the supply voltage.
mode mode
3 s
pressure
3 s
display press both arrow
arrow keys
simultaneously
use or to alter setting,
OFF
ON
= programming disabled
= programming possible (release
arrow keys)
and hold down.
down for 3 s)
voltage (hold keys
"main program state"
display
Switch on supply
Note:
• If a setting has been changed "PRG" is displayed briefly when the display is switched
over. The new setting is then saved in the unit.