Humanscale T7 - Manual (Page 32)

31
Fixed-Height Monitor Assembly
1. Mount the VESA plate to your monitor using
either the four 75 mm- or 100 mm-spaced holes
as needed.
2. Lower the monitor arm by inserting the tongue
on the back of the VESA plate into the quick-
release mount on the cart; be sure that you hear
a “click.”
Adjustable-Height (UFEA) Monitor
Assembly
1. To detach the VESA plate from the UFEA
body, first loosen the four screws inside the
UFEA track and slide the UFEA body to the left,
allowing you to pull the body away from the
VESA plate.
2. Mount the VESA plate to your monitor using
either the four 75 mm- or 100 mm-spaced holes
as needed.
3. Determine the appropriate positioning for the
UFEA on your monitor and slide the UFEA body
back on the VESA plate at the corresponding
position; be sure that you hear a “click.”
4. Slide the body to the right, setting the screws in
the smaller holes and tightening them down.
5. Lower the monitor and UFEA onto the monitor
arm by inserting the tongue on the back of the
UFEA into the quick-release mount on the cart.
5.4 MOUNTING A MONITOR
The T7 has two types of monitor mounts, fixed and height-adjustable. Both utilize a similar quick-release lock and VESA-style
mounting plate.
Adding a monitor may cause instability risks. The unit should be handled with caution with a monitor attached
After the monitor is mounted, the power and data cables can be routed inside the gantry by removing the rubber
cover on the back.