Heidolph MR Hei-Tec - Manual (Page 31)

23
Error codes
NOTICE Error code displayed on the device
1. Perform a reset.
2. Implement the measures suggested in the table below.
MR Hei-Standard
Error code Cause Consequence Measure
LED I/O flashes
one time - Heating function off.  Please contact our
Technical Service.
LED I/O flashes
two times The actual temperature
exceeds the set
temperature on the sensor of
the temperature sensor by
more than 25 °C:
a. Temperature control
defective.
b. Exothermic reaction.
c. Test setup not optimal.
 Check test setup.
 Please contact our
Technical Service.
LED I/O flashes
three times
a. Speed control knob
defective.
b. Temperature control knob
defective.
c. Heating button defective.
Heating function off.  Please contact our
Technical Service.
LED I/O flashes
four times Motor defective. Heating function off.
Stirring function off.
LED I/O flashes
five times a. Sensor break.
b. Temperature sensor is
connected or disconnected
whilst the heating function
is switched on.
(IMPORTANT: The tempera-
ture sensor must only be
connected or removed when
the heating function is
switched off)
Heating function off.  Replace temperature
sensor (only in case of
“a”.).
 Switch off the device.
 Connect temperature
sensor (see chapter
"Installation
").
 Switch on the device.
MR Hei-Tec
Error
code
Mode Cause Consequence Measure
„E11“,
„E12“,
„E13“,
„E14“
-
Heating function off.  Please contact our
Technical Service.