Bunn JDF-2 - Manual (Page 9)

9
DISPENSER USE
Press and Hold Models (Refer to Fig 5)
1. Place a cup on the drip tray beneath the desired dispensing nozzle.
2. Press and hold the “Product Dispense” switch until the beverage reaches the desired level, then release.
Portion Control Models (Refer to Fig 6)
1. Place a cup on the drip tray beneath the desired dispensing nozzle.
2. Momentarily press the appropriate cup size switch to dispense the beverage. The dispenser is factory preset
to produce the approximate beverage sizes as follows:
Small (4.0 seconds): approximately 7 fl.oz. (207 ml)
Medium (6.9 seconds): approximately 12 fl.oz. (355 ml)
Large (9.1 seconds): approximately 16 fl.oz. (473 ml)
The dispense times can be individually programmed by following the procedures described in ADJUST-
MENT - Cup Size Programming .
To stop a timed dispense, momentarily press the “+/Stop Switch”.
3. To “top-off” a beverage, press and hold the “+/Stop Switch” until the beverage reaches the desired level, then
release.
35303 012703