Gast 30R Series - Manual (Page 3)

OPERATION
Injury Hazard
Install proper safety brackets as needed to keep
fingers and objects away from openings and
rotating parts.
Product surfaces become very hot during operation,
allow product surfaces to cool before handling.
Air stream from product may contain solid or liquid
material that can result in eye or skin damage,
wear proper eye protection.
Failure to follow these instructions can result in
burns, eye injury or other serious injury.
WARNING
If connected to a 12 volt DC power source, and the
motor’s thermal protection overload has tripped,
the motor can restart after cooling.
Motor to turn counterclockwise
when looking at shaft end with:
(+) Lead of motor attached to
(+) Lead of power source
CCW
MOTOR
(RED)
- (BLACK)
Power supply wiring must conform to all required safety
codes and be installed by a qualified person. Check
that supply voltage agrees with that listed on product
nameplate. Minimum supply wire gage: 14 AWG.
It is your responsibility to operate this product at
recommended pressures or vacuum duties and ambient
temperatures.
It is your responsibility to:
• Regularly inspect and have necessary repairs
made to product in order to maintain proper
operation.
• Make sure that pressure is released from product
before starting maintenance.
MAINTENANCE
Injury Hazard
Product surfaces become very hot during operation,
allow product surfaces to cool before handling.
Air stream from product may contain solid or liquid
material that can result in eye or skin damage,
wear proper eye protection.
Clean this product in a well ventilated area.
Failure to follow these instructions can result in
burns, eye injury or other serious injury.
W ARNING
Pump does not contain serviceble parts. Replace air
compressor if it fails to operate correctly.