Gast 30R Series - Manual (Page 2)

Motor Control
It is your responsibility to contact a qualified
electrician and assure that the electrical installation is
adequate and in conformance with all national and local
codes and ordinances.
Select fuses, motor protective switches or thermal
protective switches to provide protection. Fuses act as
short circuit protection for the motor, not as protection
against overload. Incoming line fuses must be able to
withstand the motorʼs starting current.
The wiring diagram supplied with the product provides
required electrical information.
Your safety and the safety of others
is extremely important.
We have provided many important safety messages in
this manual and on your product. Always read and
obey all safety messages.
This is the safety alert symbol. This symbol
alerts you to hazards that can kill or hurt you and
others. The safety alert symbol and the words
“DANGER”and “WARNING”will precede all safety
messages. These words mean:
You will be killed or seriously injured if you donʼt follow
instructions.
You can be killed or seriously injured if you donʼt follow
instructions.
All safety messages will identify the hazard, tell you
how to reduce the chance of injury, and tell you what
can happen if the safety instructions are not followed.
Correct installation is your responsibility. Make sure you
have the proper installation conditions and that
temperatures are not excessive.
Blocking air flow over the product in any way can cause
the product to overheat.
Mounting
This product can be installed in any orientation.
Mounting the product to a stable, rigid operating surface
and using shock mounts will reduce noise and vibration.
INSTALLATION
Accessories
The productʼs intake filter will provide adequate filtration
in most applications. Check filters periodically and
replace when necessary. Consult your Gast
Distributor/Representative for additional filter
recommendations.
WARNING
DANGER
Plumbing
Connect with pipe and fittings that are the same size or
larger than the productʼs threaded ports. Be sure to
connect the exhaust plumbing to the correct outlet
ports. Ports will not support plumbing.
Install relief valves and gauges at outlet or both, to
monitor performance. Check valves may be required to
prevent back streaming through the pump.
Electrical Connection