Flex TPO 10 Pressure Sensitive - Manual (Page 2)

_____________________________________________________________________________________________________
Flex Membrane International Corp. 2670 Leiscz’s Bridge Road, Suite 400, Leesport, PA 19533
Tel: (610) 916-9500 Fax: (610) 916-9501 www.FlexRoofingSystems.com
Page 2
7. When the TPO primer is dry to the touch roll the membrane onto the strip and apply hand pressure
to the splice area.
8. Roll the entire width of the Flex TPO 10” PS Securement Strip with a 2” wide seam roller
applying positive pressure to the entire splice.
CAUTIONS AND WARNINGS
· Flex 2 3/8” TPO Plus Plates and Flex TPO XHD #15 Fasteners must be used when installing TPO
10” PS Securement Strip with Flex TPO membranes.
· Flex TPO 10” PS Securement Strip must be stored in a dry area.
· Review the MSDS documents for safety information prior to use.
· Due to solvent flash off condensation may form on freshly applied Flex TPO Primer when the
ambient temperature is near the dew point. If condensation develops the application of the strip
must be discontinued. Allow the surface to completely dry. When conditions have improved
apply a fresh coat of primer and continue with the application.
· Product should be stored between 40° F and 90° F.
· Keep out of the reach of children.
Note: Typical properties and characteristics are based on samples tested and are not guaranteed for all
samples of this product. This data and information is intended as a guide and does not reflect the
specification range for any particular property of this product.