Enerpac DGR-Series - Manual

L4009 Rev. A 01/13
DGR-2
Digital Pressure Gauge
Index:
English . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-15
Français . . . . . . . . . . . . . . . . . . . . . . . . . . 17-31
Deutsch . . . . . . . . . . . . . . . . . . . . . . . . . . 33-47
Italiano . . . . . . . . . . . . . . . . . . . . . . . . . . . 49-63
Español. . . . . . . . . . . . . . . . . . . . . . . . . . . 65-79
Nederlands . . . . . . . . . . . . . . . . . . . . . . . . 81-95
Portuguese . . . . . . . . . . . . . . . . . . . . . . . 97-111
Norwegian . . . . . . . . . . . . . . . . . . . . . . 113-127
Svensk . . . . . . . . . . . . . . . . . . . . . . . . . 129-143
1.0 IMPORTANT RECEIVING
INSTRUCTIONS
Visually inspect all components for shipping
damage. Shipping damage is not covered by
warranty. If shipping damage is found, notify
carrier at once. The carrier is responsible for
all repair and replacement costs resulting
from damage in shipment.
SAFETY FIRST
2.0 SAFETY ISSUES
Read all instructions,
warnings and
cautions carefully.
Follow all safety precautions to avoid
personal injury or property damage during
system operation. Enerpac cannot be
responsible for damage or injury resulting
from unsafe product use, lack of maintenance
or incorrect product and/or system operation.
Contact Enerpac when in doubt as to the
safety precautions and operations. If you
have never been trained on high-pressure
hydraulic safety, consult your distribution or
service center for a free Enerpac Hydraulic
safety course.
Failure to comply with the following cautions
and warnings could cause equipment
damage and personal injury.
A CAUTION is used to indicate correct operating
or maintenance procedures and practices to
prevent damage to, or destruction of
equipment or other property.
A WARNING indicates a potential danger that
requires correct procedures or practices to
avoid personal injury.
A DANGER is only used when your action
or lack of action may cause serious injury or
even death.
WARNING: Wear proper personal
protective gear when operating
hydraulic equipment.
WARNING: Stay clear of loads
supported by hydraulics. A
cylinder, when used as a load
lifting device, should never be used as a load
holding device. After the load has been raised
or lowered, it must always be blocked
mechanically.
WARNING: USE ONLY RIGID
PIECES TO HOLD LOADS.
Carefully select steel or wood
blocks that are capable of supporting the
load. Never use a hydraulic cylinder as a shim
or spacer in any lifting or pressing application.
DANGER: To avoid personal
injury keep hands and feet away
from cylinder and workpiece
during operation.
Instruction Sheet
POWERFUL SOLUTIONS. GLOBAL FORCE.