Elkhart Brass X-Stream SM1000BE – SM2000BE HL/HLGM - Manual (Page 2)

2
PRODUCT SAFETY
Important:
Before installing and operating this equipment, read & study this manual thoroughly. Proper
installation is essential to safe operation. In addition, the following points should be adhered
to in order to ensure the safety of equipment and personnel:
 All personnel who may be expected to operate this equipment must be thoroughly trained in its safe and
proper use.
 Before flowing water from this device, check that all personnel (fire service and civilian) are clear of the
stream path. Also confirm stream direction will not cause avoidable property damage.
 Become thoroughly familiar with the hydraulic characteristics of this equipment, and the pumping
system used to supply it. To produce effective fire streams, operating personnel must be properly
trained.
 Always open and close valves supplying this equipment slowly, so that the piping fills with water
slowly, thus preventing the possible occurrence of water hammer.
 After each use, and on a scheduled basis, inspect equipment per instructions in the maintenance section.
 Keep fingers and hands clear of moving parts
 Disconnect power prior to servicing.
 All equipment must be installed in accordance with ATEX requirements (EN/IEC 60079-14) as
appropriate and in areas where equipment classification is suitable.
WARNING:
Do not attempt to disconnect or work on any electrical equipment in this
system unless power is removed or the area is known to be non-hazardous.
NOZZLE INFORMATION:
DETAILS:
__________________________________________________________________________________________
__________________________________________________________________________________________
__________________________________________________________________________________________