Dreams Piccadilly TV Bed - Manual (Page 3)

Bed Assembly
Stage
1
Stage
1
Stage
2
7
7
6
8
5
D x13 F x13
Fit the barrel nuts ( F), to the Media Tray back panel (7),
making sure the screw hole aligns with the intersecting
hole (see hints & tips section).
Fit the tray side panels ( 6 & 8 ), to the back panel (7 )
using the screws ( D) into the barrel nuts.
Fit barrel nuts ( F) to the inside sides of the tray side
panels as shown.
Fit the tray base panel (5) using the screws (D) to
secure through into the barrel nuts previously fitted.
Page 3 of 9
A x16 B x16 C x16
3
2
1
4
Fit the bolts (A), spring washers (B) , and flat washers (C) to the holes in the footboard (2) as shown.
Note: Do not fully locate the bolts, but leave 10mm protruding.
Fit the side panels
(3 & 4) to the footboard locating the brackets behind the flat washers.
Fit the bolts (A), spring washers (B) , and flat washers (C) through the brackets in the central set of holes.
Once all four corners are located, make sure the bed is square, then tighten the bolts using allen key (E).
.
A B C
3
&
4
1
&
2
A B C
10mm
2
3
&
4
&
1 2