Doug Fleenor Design DMX2REL5A - Manual (Page 2)

Specifications:
Input signal: 250 Kilobaud, 0.2 volts minimum, 12 volts maximum.
Input circuit: EIA-485 receiver with two 100 ohm PTC self resetting fuses, four
low capacitance transient suppression diodes.
Input connector: Gold plated 5 pin male XLR (Neutrik D-1 series) 3 pin optional.
Input pass through: Gold plated 5 pin female (Neutrik D-1 series).
All pins are wired through.
Power Input: 120 volts, 50/60 hertz, 2 watts. (240 Volt Optional)
Output Connection: (2) Gold Plated 3 pin male XLR (Neutrik D-1 series).
pin 1 common
pin 2 normally open
pin 3 normally closed
Output Rating:
5A 30VDC
Color:
Top, bottom and sides: Silver hammer tone.
Front and back: Black.
Size and weight: 6.5" deep, 1.7" high, 6.5" wide, 2.7 pounds
(19" rack adapter available).
Warranty: Five years on defects in manufacturing.
Output device is not warranted against abuse.