Daisy AVANTI Elite 753 - Manual (Page 7)

SLING ATTACHMENT
The sling is attached to the Avanti Elite, model 753, Competition Pellet Rifle by a detachable
sling swivel which connects to a sling bracket on the forward end of the cocking lever. With the
sling attached to the swivel and then pulled back along the underside of the rifle, the tab end of the
sling should be hanging down (See drawing No. 9).
PUTTING SLING ON ARM
1. Open the arm loop.
2. Turn loop one quarter turn in the direction of the sling arm (i.e., one quarter turn to the left if the
sling is going on the left arm) and slip your arm into the loop (See Drawing 9A).
3. Place sling loop on your upper arm either above the bicep near the shoulder or below the bicep.
4. Tighten the sling loop until it is snug enough to remain in place on your arm. It should not be so
tight that it restricts the flow of blood in your arm or creates a pulse effect.
LENGTHENING SLING: Grasp the tab end of the keeper with your trigger hand and lift it up while
pulling on the top strand (not the tab end) of the sling (See drawing No. 9B).
SHORTING SLING: Pull the tab end of the sling away from you until sling reaches the desired
length (See drawing 9C).
7
NO. 9 NO. 9A
NO. 9B NO. 9C
SLING
BRACKET
TAB END
LENGTH ADJUSTING
ARM LOOP