Daisy AVANTI Elite 753 - Manual (Page 6)

REAR SIGHT INSTALLATION AND ADJUSTMENT
This is a universal target sight with a rubber eyepiece, which prevents light reflecting from the
sight into your eye.
Installation: Mounting is accomplished on the dovetailed receiver of the Avanti Elite, model 753,
Competition Pellet Rifle by loosening the mounting screw and plate, and sliding the sight onto the
dovetail grooves of the receiver. Position sight where you want it in relation to your eyesight and/or
physique. Tighten mounting screw securely.
ELEVATION:
To lower the point of impact, turn elevation knob to the left
(counterclockwise). To raise the point of impact, turn elevation knob to the right (clockwise),
per arrow and word “UP” (See drawing No. 7)
WINDAGE:
To move the point of impact to the left, turn the windage knob counterclockwise. To
move the point of impact to the right, turn the windage knob clockwise.
Note: This precision peep sight is fully adjustable. Its micrometer mechanism is gauged to adjust
0.002 of an inch or 0.0508 millimeter per click.
FRONT SIGHT APERTURE INSERTS:
Your Avanti Elite, model 753, Competition Pellet
Rifle comes with four aperture inserts, with one already in place. To change inserts, follow this
procedure:
1. Point the muzzle up and away from you.
2. Grip the ring at the back of the sight and turn counterclockwise. If tight, a coin may be used in
the slots.
3. Unscrew until aperture is free to be removed by using finger and thumb on side of sight tube,
engaging ears on aperture to pull back and upwards.
Note: Apertures have ears of different sizes to ensure the proper positioning when replaced.
4. To install, make sure back locking ring is unscrewed far enough for clearance. Have ears to
proper side. Insert in groove and push forward. Tighten locking ring. A coin may be used to assure
a firm lock.
6
NO. 6 NO. 7
NO. 8 NO. 8A
ELEVATION
ADJUSTMENT
KNOB
WINDAGE
ADJUSTMENT
KNOB
WINDAGE
ELEVATION
MOUNTING
APERTURE