Daisy PowerLine 15XTP - Manual

WARNING:
THIS GUN CAN CAUSE DEATH IF CARELESSLY USED
OR MISUSED. READ AND FOLLOW THE INSTRUCTIONS CAREFULLY. DO NOT LOAD
ANY BBs INTO THE GUN UNTIL YOU ARE READY TO SHOOT. IF YOU DO LOAD BBs
INTO THE GUN AND THEN DECIDE NOT TO SHOOT, EITHER MANUALLY REMOVE THE
BBs FROM THE GUN OR SHOOT THE REMAINING BBs AT A SAFE TARGET. AN
UNLOADED, NON-PRESSURIZED GUN WHICH IS “ON” SAFETY IS SAFEST. ACCI-
DENTS HAPPEN FAST, AND ACCIDENTALLY INJURING OR KILLING SOMEONE IS A
TERRIBLE THING. PLEASE SHOOT SAFELY.
This safety alert symbol indicates important safety messages in this manual. When
you see this symbol, be alert to the possibility of personal injury and carefully read
the message that follows.
The Model 15XT CO2 PowerLine pistol shoots with much more muzzle energy than
most BB and pellet guns. Use extreme caution when operating this gun.
Although your new PowerLine pistol is not a firearm, it has lethal potential and should
be treated with the caution and respect due any conventional firearm. Like a firearm, your
PowerLine pistol, when misused or carelessly used, can kill or seriously injure the shoot-
er or other persons. Always remember, the first and most important safety feature of any
gun is the shooter. All safeties are mechanical devices and the shooter is the only part of
the system that can make a gun safe–or unsafe. DON’T DEPEND ON MECHANICAL
SAFETIES–think ahead and avoid situations that might lead to accidents.
Guns differ in their operation, and you are never ready to fire any gun until you are thor-
oughly familiar with it. Read the following operating instructions and WITHOUT LOADING
ANY AMMUNITION, proceed through the operating steps, dry firing your gun with CO2 only
several times at a safe target. This will enable you to learn to operate the PowerLine 15XT
properly and safely.
NOT A TOY. ADULT SUPERVISION REQUIRED. MISUSE OR
CARELESS USE MAY CAUSE SERIOUS INJURY OR DEATH. MAY BE DANGEROUS UP TO
240 YARDS (220 METERS).
THIS IS A HIGH POWER AIR GUN RECOMMENDED FOR USE BY THOSE 16 YEARS OF
AGE OR OLDER. READ ALL INSTRUCTIONS BEFORE USING. THE PURCHASER AND
USER SHOULD CONFORM TO ALL LAWS GOVERNING USE AND OWNERSHIP OF AIR GUNS.
15XT .177 cal BB (4.5 mm) STEEL AIRGUN SHOT
12gm CO2 cylinder only
MODEL 15XT By
CO2 SEMI-AUTOMATIC
WARNING:
O P E R A T I O N M A N U A L
NEVER STORE A LOADED GUN
At the end of a shooting session, as a safety precaution, always put “ON” safety – NO RED
SHOWING, remove CO2 cylinder and remove BBs from the built-in Magazine. Store in a safe
place to prevent unauthorized use.
HOW TO OPERATE
WARNING: Be sure gun is always pointed in a safe direction. Never point the gun at anyone.
Always assume and treat the gun as if it were loaded and ready to fire.
STEP 1. PUT “ON” SAFETY – POSITION SAFETY SO NO RED IS SHOWING.
Push the safety button to the right toward the “SAFE” position – NO RED SHOWING (Fig. 2). In
this position, the trigger cannot be pulled to fire the gun.
CAUTION: Even when the safety is “ON” you should continue to handle the pistol safely. Don’t
point the gun at anything that you don’t intend to shoot.
NOTE: The safety is manual and not automatic. It will only do its job when you do yours. With
the index finger out of the trigger area, move the safety to the “SAFE” position-NO RED
SHOWING (Fig. 2). REMEMBER, THE BEST SAFETY IS GOOD GUN HANDLING.
STEP 2. INSERT CO2 CYLINDER
A. Put "ON" safety - NO RED SHOWING.
B. Remove left grip cover by lifting the grip cover tab (Fig. 3).
C. Turn puncture screw counterclockwise until there is enough room to insert a CO2 cylinder.
D. Insert the large end of the CO2 cylinder into the lower portion of the grip. Hold the gun in
an inverted position with the grip pointing up and the muzzle pointing away from you as
shown (Fig. 4). Position the small end of the CO2 cylinder inside the retainer so that
the CO2 cylinder touches the puncture pin (Fig. 4).
E. While continuing to hold gun in an inverted position, replace the left grip cover, point the
muzzle in a safe direction and turn the puncture screw clockwise to puncture the CO2
cylinder. (Fig. 5) Continue turning the screw RAPIDLY until finger tight. NOTE: A slight
seepage of CO2 gas may occur until puncture screw is tight.
WARNING: Be sure the muzzle is pointed in a safe direction when puncturing a CO2 cylinder.
In the event that a seal temporarily leaks while a CO2 cylinder is being punctured, the CO2 gas
may escape through the barrel. If ammunition is jammed in the barrel from prior shooting, this
could result in a projectile being shot.
WARNING: Use only 12 gram CO2 cylinders. Any attempt to use other types of gas cylinders
could be extremely dangerous and could result in serious injury. Gasses other than CO2 could
result in an explosion or rupture of the gun.
STEP 3. FILL THE BUILT-IN MAGAZINE WITH A MAXIMUM OF 15 BBs
A. Always point gun in a safe direction. Insure that the gun is “ON” safe – NO RED SHOWING
(see Operation Step 1).
B. Move the Built-in Magazine BB follower fully forward and hold in position as shown. (Fig. 6-1)
NOTE: Make sure the follower is held Fully forward toward the muzzle of the gun and the
spring is clear of the loading port before attempting to load BBs.
C. Once the Magazine BB follower is held fully forward, a maximum of 15 .177 caliber BBs can be
individually inserted into the Magazine Loading Port as shown. (Fig. 6-2)
CAUTION: Use only Precision Max™ BBs by Daisy®, or similar quality BBs that are labeled as
such. Do not use lead pellets, buck shot, darts, ball bearings, or other foreign objects because they
can cause injury to someone or may damage and/or jam the pistol.
D. After the Built-in Magazine has been loaded with a maximum of 15 BBs, slowly release the
Built-in Magazine BB follower and allow it to rest up against the BBs. This will allow the BBs to
be under spring tension (Fig. 7).
WARNING: Once the Built-in Magazine is loaded with BBs it is considered to be loaded, so use
extreme caution in handling the gun. Keep the gun pointed in a safe direction. Never point the gun
at anyone. Always treat the gun as if it were loaded and ready to fire.
STEP 4. AIM AT A SAFE TARGET
To be a consistent marksman, use the correct sight picture each time you fire the pistol (Fig 8).
CAUTION: Due to the power of the Model 15XT, use extra precaution in selecting a safe target.
Improper targets may cause ricochet.
STEP 5. TAKE “OFF” SAFETY – RED SHOWING.
When you are certain that the target, back-stop and surrounding area is safe, position the
safety “OFF” – RED SHOWING (Fig. 9). Pulling the trigger now will fire the gun.
STEP 6. FIRE
Make sure the gun is pointed at a safe target. Once the last BB has been shot from the gun, it
is still possible for the trigger to be pulled, but only CO2 will be discharged.
STEP 7. PUT “ON” SAFETY - NO RED SHOWING.
After firing, return the safety to the “ON” position – NO RED SHOWING (Fig 2).
FRONT SIGHT
MUZZLE
TRIGGER
REAR SIGHT
SAFETY
GRIP
PUNCTURE SCREW
FIG. 1
FIG. 2
FIG. 8
BULLSEYE
REAR SIGHT
FRONT SIGHT
FIG. 4
FIG. 3
12 gm CO 2 CYLINDER
FIG. 5
PUNCTURE
SCREW
SLOWLY RELEASE
THE MAGAZINE BB FOLLOWER
SAFETY “OFF” Red Showing
SAFETY “ON”
No Red Showing
3/8” DOVETAIL MOUNT 15-SHOT MAGAZINE
3/8” DOVETAIL MOUNT
1
2
FIG. 6 FIG. 7
FIG. 11
FIG. 9
FIG. 10
GRIP COVER
PUNCTURE SCREW
PRIOR TO OPERATION
Put “ON” SAFE – NO RED SHOWING (refer to Operation Step 1).
OPERATION STEPS:
WARNING: Be sure gun is always pointed in a safe direction. Never point the gun at anyone.
Always assume and treat the gun as if it were loaded and ready to fire.
Gun may continue to be fired (Steps 5 and 6) until the built-in BB magazine is empty or the
CO2 cylinder needs to be replaced. Once the built-in BB magazine is empty, Steps 1,3,4,5,6,
and 7 should be followed. If the CO2 cylinder is empty, then all 7 Steps should be followed.
(Approximately 150 shots can be expected per CO2 cylinder).
Step 1. Put "ON" safety - No red showing.
Step 2. Insert CO2 Cylinder
Step 3. Fill built-in magazine with a
maximum of 15 BBs.
Step 4. Aim at a safe target.
Step 5. Take "OFF" safety - Red showing.
Step 6. Fire.
Step 7. Put “ON” safety - No red showing.