Condux CableGlider Cable Pullers - Manual (Page 10)

!CAUTION: The self-tailing
capstan’s bronze components
are not meant to rotate. Never
overwrap rope on them. Damage
to the puller will result. Do not
run the rope directly from the
sheave to the self-tailer. Damage
to the self-tailer will result.
(See Figure 5)
NOTE: Use low temp grease
(i.e.: Molub-Alloy 4086-1). Before
use, always check to make sure
the anti-rotation pawl is functioning
properly. Grease after 10-15 hours of use.
!WARNING: The rope is under
tension and could break. Stand at
least 30° to either side of the rope.
Recoil force could cause serious
personal injury or death.
(See Figure 6)
6. Re-adjust the puller if necessary to
assure maximum stability against
pulling torque.
7. Plug cable puller into 110-120V
20 amp twist outlet. (For Standard
Duty and Plus models you may use
110-120V 15 amp standard outlet.)
220V motors available upon request.
!DANGER: Electrical equipment is very hazardous in wet
areas. Properly ground the puller (see Figures 7 & 8), wear
insulated footwear and gloves, keep the operator zone dry,
and keep cords dry and in good condition. Failure to do so
could result in serious personal injury or death.
9
Figure 7
(Twist plug/outlet)
Figure 8
(Standard plug/outlet and adapter)
Figure 5
30
°
30
°
FOOT
CONTROL
OPERATOR
Hazard Zone
Figure 6