Comelit MU 6501 - Manual (Page 16)

EN
16
USER MENU
Memory
Melodies Settings
Key tone
Set language
Calibrate touch-screen
USER MENU
Melodies Settings
Key tone
Set language
Sat 12/06/13 01:21
INTERCOM ACTUATORS
USER PROGRAMMER
ALARM
CAMERAS
English
Français
Español
MODIFY LANGUAGE
Italiano
INTERCOM CAMERAS
PROGRAMMER USER
Sat 12/06/13 01:21
The "calibrate touch-screen" function is used to calibrate
the sensitivity of the display to your "touch".
Functions that can be activated by the
installer
A. ACTUATOR DIRECTORY (disabled by default but can
be enabled by the installer) can be used to activate the
relay for a specifi c actuator installed in the system.
B. ALARM ACTIVATION (disabled by default but can be
activated by the installer) can be used to enable the
alarm system.
2. Press "Calibrate touch-screen" to access the calibration
screen (use to scroll through the menu).
3. Press the record dot ( ) shown on the screen.
Calibrating the touch-screen
PROGAMMER MENU
CONFIGURATION COMPLETE
1. Press PROGRAMMER to access the INSTALLER
MENU.
2. Enter the password.
3. Press
to confi rm the password and access the
INSTALLER MENU.
The programmer menu can be used to confi gure the
buttons with standard functions, to confi gure the monitor
address and to set special functions.
1. Press USER to access the USER MENU.
2. Press "Set language" to access the CHANGE
LANGUAGE screen.
1. Press USER to access the USER MENU.
Setting the language
3. Press the selected language.
4. Press CONFIRM to save the language selection or
CANCEL to return to the CHANGE LANGUAGE screen
without saving the changes.
Call divert (not confi gured by default but can be
programmed by the installer).
List of messages received by the switchboard
(not confi gured by default but can be programmed
by the installer).
Energy messages (not confi gured by default but
can be programmed by the installer).
shortcut menu